Darkglass Electronics Microtubes X7 Bass Distortion Pedal - Osto

Front Features

High Pass Frequency

• Controls the cutoff frequency to be distorted, ranging from 100Hz (for thicker, fuzzier saturation) or 1kHz for ultra-sharp definition.

High Drive

• Sets the amount of distortion for the high pass side.

High Level

• Sets the output volume of the distorted high-pass signal.

Low Pass Frequency

• Controls the cutoff frequency to be mixed back to the high-pass side. Ranging from 50Hz (for only sub-bass) and 500Hz to preserve some clean mids.

Low Comp

• Sets the amount of compression for the low-pass signal.

Low Level

• Sets the output volume of the low-pass signal.

Master

• Sets the overall volume of the unit.

Low shelf

• +-12dB @ 80 Hz

500 Hz

• +-12dB

1 kHz

• +-12dB

High shelf

• +-12dB @ 5 kHz

Dimensions

• Width : 94 mm / 3¾″
• Length : 120 mm/ 4¾″
• Height : 46 mm / 1¾″

Input & Outputs

Output

• Connect from the ¼” Output jack to the input of your amplifier or another effects pedal.

Ground Lift

• Use this control to lift the ground of the XLR output. If you are experiencing ground noise in your DI signal, try changing this control.

Direct Output

• A balanced version of the ¼” output, useful for running into PA’s or studio mixing consoles.

Input

• Connect your instrument or output from your pedal board to the ¼” mono jack.

9V DC

• Only use a regulated 9V DC adapter with a center-negative plug.

Parallel Output

• A passthrough for your input signal is useful for parallel processing.