Boss OS-2 Overdrive & Distortion + Power Supply

Boss OS-2 Overdrive & Distortion

• Flexible distortion pedal capable of producing blended overdrive/distortion sounds
• Provides both "over-the-top" distortion sounds and less extreme overdrive tones for rhythm playing
• Includes Level, Tone, Drive and Color controls for precise tonal shaping

Nominal Input Level : -20 dBu

Input Impedance : 1 M ohm

Nominal Output Level : -20 dBu

Output Impedance : 1 k ohm

Recommended Load Impedance : 10 k ohms or greater

Bypass : Buffered bypass

Controls

• COLOR knob
• DRIVE knob
• TONE knob
• LEVEL knob
• Pedal switch

Indicator : CHECK indicator (Used for indication of check battery)

Connectors

• INPUT jack : 1/4-inch phone type
• OUTPUT jack : 1/4-inch phone type
• DC IN jack

Power Supply : Carbon-zinc battery (9 V, 6F22) or Alkaline battery (9 V, 6LR61)

Current Draw : 12 mA

Expected battery life under continuous use

• Carbon : Approx. 38.0 hours
• Alkaline : Approx. 61.5 hours
• These figures will vary depending on the actual conditions of use.

Accessories

• Owner's manual
• Leaflet ("USING THE UNIT SAFELY," "IMPORTANT NOTES," and "Information")
• Carbon-zinc battery (9 V, 6F22)

Size

• Width : 73 mm, 2-7/8 inches
• Depth : 129 mm, 5-1/8 inches
• Height : 59 mm, 2-3/8 inches

9V Power Supply

• 9V power supply with 1000 mA can power up to 10 pedals at once
• Space saving low-profile design takes up a single slot on a power strip
• 10 ft (3 meter) cable so you can set up further away from a power source
• 110-240v compatible for international use
• Works with most effects pedals on the market and is a suitable replacement for any of the following: Boss PSA or ACA, Dunlop ECB-03, Zoom AD-0006, Danelectro DA-1, DOD PS-200R, Ibanez AC-109, Korg A30950, Morley 9V