|
1600W/ch @ 2 ohms 1200W/ch @ 4 ohms 650W/ch @ 8 ohms 3200W bridged mono @ 4 ohms 2400W bridged mono @ 8 ohms.
Integrated proprietary DSP with LCD front panel display
Accurate, uncolored sound with very low distortion for the best in music and voice reproduction
Advanced protection circuitry guards against: shorted outputs, open circuits, DC, mismatched loads, general overheating, high-frequency overloads and internal faults
Extremely versatile, handling a wide range of speaker impedances and outputs
Switch-mode universal power supply
Speaker presets for crossover frequencies, EQ, limiting, and delay
All products fill 2U rack spaces and weigh under 17 pounds; weight sets a new standard in lightweight amps (20% less)
Speakon® and binding post outputs, XLR inputs and loop-thrus
Comprehensive LED status per channel
Three-Year, No-Fault, Fully Transferable Warranty completely protects your investment and guarantees its specifications
Specifications
Sensitivity (volts RMS) for full rated power at 4 ohms
1.4V
Frequency Response (at 1 watt into 4 ohms, 20Hz - 20 kHz)
+0/–1 dB
Signal to Noise Ratio (below rated 1 kHz power at 8 ohms), A-weighted
100 dB
Damping Factor (8 ohm): 20 Hz to 400 Hz
> 500
Input Stage
Input is electronically balanced and employs
precision 1% resistors.
AC Line Current
XTi 1000: 6.5A, XTi 2000: 6.9A, XTi 4000: 8.0A.
At idle: Draws no more than 90 watts.
Crosstalk (below rated power) 20 Hz to 1 kHz
> 70 dB
Input Impedance (nominal)
20 kilohms balanced, 10 kilohms unbalanced
Load impedance (note: safe with all types of loads)
Stereo
Bridge mono
2-8 ohms (4-8 ohms in XTi 1000 A1 100V versions)
4-16 ohms (8-16 ohms in XTi 1000 A1 100V versions)
Voltage Gain (at 1 kHz, 8 ohm rated output)
XTi 1000: 30.5 dB. XTi 2000: 32.9 dB.
XTi 4000: 34.2 dB
Maximum Input Signal
+22 dBu typical
Operating Temperature
0° C to 40° C at 95% relative humidity
(non-condensing)
AC Line Voltage and Frequency Configurations Available (± 10%)
100V, 120V, 220-240V 50/60 Hz
Ventilation
Flow-through ventilation from front to back
Cooling
Heat sinks and proportional-speed fan
Dimensions: Width, Height, Depth (behind mounting surface)
EIA Standard 19 in. W (EIA RS-310-B)
x 3.5 in. (8.9 cm) H x12.25 in. (31.1cm) D
Net Weight, Shipping Weight
18.5 lb (8.4 kg), 21.5 lb (9.8 kg)
|
