Pressure-Gradient Transducer: 1.06 in. (27mm) 6um mylar diaphragm

FET impedance converter

Five Polar Patterns: Cardioid, Wide Cardioid, Hyper Cardioid, Omni, Fig 8

-5dB, -10dB, -15dB, and -20dB Pads

50Hz, 75Hz, 150Hz, and 300Hz High Pass Filters @ 6dB/octave

15kHz, 7kHz, 5kHz, and 3kHz, Low Pass Filters @ 6dB/octave

Applications

Close miking of instruments with high SPLs

Announcer’s mic for broadcasting/dubbing

Home recording and project studios

Vocalist recording

Spot mic for: wind instruments, strings, percussion and guitar amps

XY - Coincident Cardioids

Mid-Side Method

Stereosonic Technique (Blumlein)

Overheads

Technical Info
Included Accessories

Shockmount

Foam wind screen

Case

CS5 Specifications

Type: Pressure gradient transducer microphone

Polar patterns: Cardioid, wide-cardioid, hypercardioid, omni, and figure-8

Frequency response: 20~20,000Hz.

Sensitivity: 14mV/Pa=-32dB(0dB=1V/Pa)

Output impedance: 200 ohm

Load impedance: 1000 ohm

Maximum SPL: 136 dB SPL for 1% THD @1,000Hz (0dB SPL=0.00002Pa) 156dB with -20dB preattenuation

Equivalent Noise Level: 13dB-A

S/N: 81 dB-A

Power requirement: 48 +/- 4V.

Current consumption: 4mA

Circuit: JFET impedance converter, discrete balanced output.

Connector: Gold-plated 3-pin XLR

Size: dia. 2 in. (52mm) length 8.5 in. (215mm)

Pads: -5dB, -10dB, -15dB, and -20dB selectable

High Pass Filters: 50Hz, 75Hz, 150Hz, and 300Hz 6dB/Octave

Low Pass Filters: 15kHz, 7kHz, 5kHz, and 3kHz 6dB/Octave